2/14/2023 0 Comments Ms lync 2013 no certificate![]() ![]() So we ran a test from every Front End server to Ĭonnected successfully from each Front End Server. Generally when I’ve had a Lync issue between the Front End and Edge Servers its firewall related. This will also cause an issue when you run “ Setup or Remove Lync Server Components ” If you specify the fqdn in topology builder but the computer name is just lyncedge2 without the you will have an issue. Went back into the Computer Name settings on the Edge Server to double check we had manually added this in. Not sure it would’ve mattered in the end but everything lined up.Īs the Edge server is not joined to the domain a domain suffix doesn’t get applied. I stress this point because we found articles that indicated the names specified in the topology had to match the server name, even the case. Then verified all the FQDN’s in the certificate we applied. Logged back into the server and checked the computer name, also all in lower case. It was spelled correctly and all lower case. Went back to the Topology Builder and took note of the name that was entered when we added the server to the topology. So we ran Get-CsManagementStoreReplicationStatus again: All event logs that related to “replication” came back clean no errors. ![]() We watched the eventlogs on the CMS Master server we ran this from. PS C:\Usersp2tuser> Invoke-CsManagementStoreReplication Ran the following command from one of the Front End Servers PS C:Userspipe2text> Get-CsManagementStoreReplicationStatus Scroll down to the output below for and you will notice the UpToDate value is False and LastStatusReport is blank To determine what is replicating and what is not, run the following command. This article will guide you thru all the steps we went thru to try to figure out the issue. The most difficult part of trying to figure this out is that there was almost no indication in any of the Lync Server event logs that there was any issue. No matter what we tried we could not get the system to replicate. For purposed of this article the problem edge server is named “”. We recently added a new Edge server to a pre-existing Lync 2013 Edge pool in our primary site.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |